![]() Enter ‘5060’ into the Start Port and End Port for the ‘Triggering Range’ and ‘Forwarded Range’ fields.ġ. On the Admin page, Click Applications and Gaming.Ĥ. Under Application Layer Gateway, verify SIP is unchecked. On the left side of the screen, click on Connectivity.ģ. To disable, execute the following command:ġ. If you are using the VoIP profile for SCCP, execute the following command:įirst, check if SIP ALG is currently enabled or disabled by running: The second method is disabling the SIP ALG in a VoIP profile. Confirm it is deleted by executing this command: Find the SIP session instance indicated by #12Ĥ. Execute these commands from the CLI interface:Ģ. Uncheck the Enable SIP ALG box and Click Apply.ġ. Enter the username (admin) and password (admin), then click Log In.Ħ. You will be prompted to provide a username and password, which are the same you’d have used to access the web interface.įor Draytek Vigor2750 and Vigor2130, type these commands:ģ. If you don’t have a web interface, then you’ll need a telnet client.ģ. Go to the regular interface at Network -> NAT -> ALG.Ģ. Uncheck SIP from Application Level Gateway Configuration and Click Save.ġ. Set both UDP and TCP Endpoint Filtering to Endpoint Independent.ĥ. Go to ‘Class inspection_default’ under ‘Policy-map global_policy’.Ģ.Locate the Application Level Gateway (ALG) Configuration.ģ. Whitelist VoiceHost IP ranges and save all changes.įor Cisco General and Enterprise-Class routers: Browse to IPADDRESS/f_general_hidden.htm.ġ0. Ensure that the following are disabled:ħ. Ensure that Firewall and Remote Management are checked.ĥ. Update firmware by going to System Management > Firmware Upgrade.Ĥ. ![]() Go to System Summary and ensure that the firmware is up to date (1.1.1.06 or later).Ģ. Click the “Disabled” check box next to any rules named LAN-2-INTERNET-SIP and INTERNET-2-LAN-SIPġ. Go to Firewall > Firewall Rules > Custom Firewall Access RulesĢ. Turn off ESP Header Forwarding and Click Save.ġ. Turn off the Authentication Header Forwarding.Ħ. Under the Firewall, click on Advanced Firewall.ĥ. Authenticate without a username, and use the password located on the unit’s sticker.ģ. Use the Username: admin and Password: motorolaĢ. Check the box to Allow Incoming WAN ICMP Echo Requests, then click Apply.Ģ. Select Advanced, click Yes to accept the warning, then click Remote Administration.Ĥ. Select Advanced, click Yes to accept the warning, then click ALG’s.Ģ.Ensure SIP ALG is disabled by removing the check and click Apply.ģ. Another option to disable SIP is via Telnet.ġ. Disable the option SIP Passthrough under Advanced Settings / WAN -> NAT Passthrough.Ģ. How Do I Turn Off SIP ALG on My Router? Routerġ.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |